Battery power to your DIY Device

-

Alot of the projects we work with require a battery. This is one solution NOTICE: This is for instructional purposes only! These batteries are explosive and there are many ways to hurt yourself or burn your house down. If your not intelligent enough to understand the dangers STOP. Go play a video game instead

LiPO usb battery charger about 2.50 china
about 4 bucks ebay

This is a maker supplement instructional for making a Li Po battery source with a charger port
The battery has protection circuit that the charger omits.

I have included the supplier info so you don’t go at this blindly , there are 2 components
The battery and the charger

Battery: Premium 102050 3.7V, 1000mAh rechargeable Li-Po battery, Built-in smart protective PCB charging module, effectively prevents over charging, over discharging, over current, short circuit.

Specifications :Model: 102050Type: Lithium batteryCapacity: 1000mAhRechargeable: YESCharging Voltage: 4.2VRated Voltage: 3.7VWorking Temperature: -10┬░~50┬░Dimensions(L*W*H): About 50x20x10

Charger:
Type C USB Input High Current 3A Polymer Ternary Lithium Battery Quick Fast Charging Board IP2312 CC/CV Mode 5V To 4.2V

it took about an hour to bring these new batteries to full charge

It looks like the device shares the same pads as the battery. Next I will add the device wire and terminal when it’s defined. This battery setup is for the portable vibration sensor with the data logger in another project. Performance and seps will be recorded there when the project moves to build status

Category:
Comments (0)

Leave a Reply

Your email address will not be published. Required fields are marked *